Showing results: 16 - 30 of 481 items found.
-
OS420 -
Advanced Fiber Solutions
The OS420 light source is for premises and campus cabling networks with multimode fiber, or single-mode fibers under 5km. The ST connector outputs can be adapted to any cable plant with hybrid adapters or hybrid cables. The OS420 becomes a powerful low cost troubleshooting and maintenance tool when used with an Advanced Fiber Solutions OM120 or OM220.
-
OS405 -
Advanced Fiber Solutions
The OS405 (635nm) visible laser cable fault locator allows the operator to find faults in fiber optic cables, even in the OTDR dead zone, optimizing splices and tracing fibers. By injecting a bright red visible light in the fiber, locations of losses such as breaks, bends, or bad connectors can be detected visually, even through the typical yellow or orange jacket used on most single fiber cables.
-
McPherson, Inc.
The unique dual-output of equivalent beams make it a useful source for many comparative applications in addition to wavelength calibration and so on. The two output beams originate from two views of the single emitting spot where the electron beam from the single hairpin filament collides with the interchangeable anode.
-
FluxData, Inc.
Modular sources are available for illumination, excitation and calibration, with options for UV, Visible and NIR wavelengths.
-
Ocean Insight
Modular sources are available for illumination, excitation and calibration, with options for UV, Visible and NIR wavelengths.
-
OrienTek Optical Technology Ltd.
High Precision● Highly accurate unit offering 6 calibrated wavelengths● Interchangeable connectors● Durable and reliable design● Easy-to-use interface forerror-free testing● Rubber armor protection
-
Evident Scientific
These external units provide illumination which is transmitted to the viewing instrument by a light guide cable, and then through the scope via the integral fiber bundle to the viewing tip.
-
FiberPal OT-3000 -
Radiantech, Inc.
The OT-3220/3221 is designed for a high performance stabilized laser source, especially in practice for FTTX networking installation and maintenance fieldworks environment requirements. It is usually applied as stable laser sources for wide range of optical testers and tools in optical fiber cabling and transmission systems.
-
UVF-352S -
SAN-EI ELECTRIC CO.,LTD.
This is the ultra high power unit fully utilizing the high stability and long life 350watt ultra high pressure mercury lamp. The unit is made to compact size.
-
UVF-210S -
SAN-EI ELECTRIC CO.,LTD.
By traversing two light guide ends (right and left) by means of the high accuracy air cylinder, alternating irradiation of two independent positions is possible.
-
UVF-204S -
SAN-EI ELECTRIC CO.,LTD.
This is the ultra compact and light weight high power unit fully utilizing characteristics of the high stability and long life 200watt mercury xenon lamp.
-
UVM-SP-JW -
SAN-EI ELECTRIC CO.,LTD.
Readouts of UV intensity and cumulative luminescence count are prompted either on the front panel or via the externally connected remote signal control. The UV intensity detection segment is intended to measure a specific intensity of light signals, while the cumulative luminescence count is designed to tally a cumulative count on all UV intensities measured, in conjunction with real-time calibration.
-
UVF-502S -
SAN-EI ELECTRIC CO.,LTD.
In combination use with the uniform exposure unit, selection of uniform irradiation area in the range of 80mm200mm is possible.
-
-
UVF-205S -
SAN-EI ELECTRIC CO.,LTD.
By use of the light guide with the quartz sensor fiber, feed-back control and monitoring of UV irradiation intensity is possible. Also setting of UV intensity and meaurement by personal computer is possible